Juniper MX204 Hardware Manual page 101

To connect a management console:
1. Turn off power to the console device.
2. Plug the RJ-45 end of the serial cable (see
3. Plug the female DB-9 end into the device's serial port.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 41: Console and Auxiliary Cable Connector
Figure 42: Connecting the MX204 Router to a Management Console Through a Console Server
CON
To Console
port
Figure 43: Connecting the MX204 Router Directly to a Management Console
Figure 41 on page
Console server
104) into the CON port on the router.
PC
104