Connecting The Mx204 To Power; Tools And Parts Required For Mx204 Router Grounding And Power Connections - Juniper MX204 Hardware Manual

Connecting the MX204 to Power

IN THIS SECTION

Tools and Parts Required for MX204 Router Grounding and Power Connections | 89

Grounding the MX204 Router | 90
Connecting Power to an AC-Powered MX204 Router | 91
Powering On an AC-Powered MX204 Router | 94
Connecting Power to a DC-Powered MX204 Router | 95
Powering On a DC-Powered MX204 Router | 98
Powering Off the MX204 Router | 99
Tools and Parts Required for MX204 Router Grounding and Power
Connections
To ground and provide power to the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
Socket nut driver
2.5-mm flat-blade (-) screwdriver
Torque-controlled driver, with a maximum torque capacity of 6 lb-in. (0.7 Nm), for tightening screws to
terminals on each power supply on a DC-powered router
CAUTION:
is 6 lb-in. (0.7 Nm). The terminal screws might be damaged if excessive torque is applied.
Use only a torque-controlled driver to tighten screws on the DC power supply terminals.
Use an appropriately sized driver, with a maximum torque capacity of 6 lb-in. or less.
Ensure that the driver is undamaged and properly calibrated and that you have been
trained in its use. You might want to use a driver that is designed to prevent overtorque
when the preset torque level is achieved.
Wire cutters
Electrostatic discharge (ESD) grounding wrist strap
The maximum torque rating of the terminal screws on the DC power supply
89