HONDA
CYLINDER HEADIVALVE
Install the O-rings and dowel pins.
Coat the cylinder and head surfaces with liquid
sealer, and install the head gasket. Make sure
that the oil orifices are not covered by gasket.
Install the cylinder drain bolts.
Remove the timing inspection cap.
Check the timing mark to be certain that the
cylinder to be serviced is a t TDC on the
compression stroke.
NOTE
/
Align the index mark with the "TR"
I
mark for the right cylinder.
Align the index mark with the "TL"
mark for the left cylinder.
Install each cylinder head.
Install the dowel pins.
Insert the push rods into the rocker arm retain-
ers.
NOTE
I
Apply molybdenum disulfide grease to
I
1
the end of each push rod.
g?,;,;.
OWEL PIN
Date of Issue: January, 1981
o
HONDA MOTOR
CO., LTD.
6-15