Honda CX500 1978 Shop Manual page 197

HONDA
CXSOO
REAR WHEELIBRAKEI
FINAL DRIVEISUSPENSION
Apply a thin coating of Prussian Blue to the
pinion gear teeth for gear tooth contact pattern
check, prior to installing the ring gear.
Assemble the ring gear shim and ring gear in
the gear case. Install the left gear case cover.
NOTE
Do not allow the left gear case cover t o
tilt during installing.
Tighten the three cover bolts showing the sign
0
in 2-3 steps until the left gear case cover
touches the gear case. Torque to the specified
tension in a cross pattern in two or more Steps.
TORQUE SPECIFICATION:
8 mm bolt: 2.3-2.8 kg-m (17-20 ft-lbs)
10 mm bolt: 3.5-4.5 kg-m (25-33 ft-lbs)
nm BOLT
1.1
Install the preload retainer A with the oil seal
and O-ring assembled in the retainer.
Before the retainer bottoms against the bearing,
.......
measure the torque T to overcome the friction
-
caused by the O-ring.
$ ? ? !
.:.
...
!
....
Tighten the retainer to T
t
4.0 kg.m ( T
t
29
ft-
[.,
:
.
.,
Ibs) back-off, and retorque to T
+
1.0 kg-m
( T
+
7 ft-lbs).
FIN
1nra1
NOTE
After assembling the final gear case, per-
form the following operations:
Backlash inspection
Final gear preload check
Final gear tooth contact pattern check
Date of Issue: January. 1978
OHONDA MOTOR CO., LTD.