D-Link DGS-1250 Series Reference Manual page 118

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
The fields that can be configured or displayed for MLD Snooping Groups Table are described below:
Parameter
VID
Group Address
FM
Exp (sec)
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to view all the entries.
MLD Snooping Mrouter Settings
This window is used to display and configure the specified interface(s) as the router ports or forbidden to be IPv6
multicast router ports on the VLAN interface on the Switch.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping
Mrouter Settings, as shown below:
The fields that can be configured in MLD Snooping Mrouter Settings are described below:
Parameter
VID
Configuration
From Port - To Port
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Description
Click the radio button and enter a VLAN ID of the multicast group. The range is
from 1 to 4094.
Click the radio button and enter an IPv6 multicast group address.
Displays the filter mode. The following can be displayed:
• EX (Exclude) - The filter mode is Exclude.
• IN (Include) - The filter mode is Include.
Displays the time left in seconds before the entry expires.
Figure 5-54 MLD Snooping Mrouter Settings Window
Description
Enter a VLAN ID between 1 and 4094.
Select the port configuration. Options to choose from are Port, Forbidden Port,
and Learn pimv6.
• Port - Select to have the configured ports as being connected to multicast-
enabled routers.
• Forbidden Port - Select to have the configured ports as being not connected
to multicast-enabled routers.
• Learn pimv6 - Select to enable dynamic learning of multicast router port.
Select the appropriate port range used for the configuration here.
109