D-Link DGS-1250 Series Reference Manual page 117

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
Parameter
Max Response Time
Robustness Value
Last Listener Query Interval
Click the Apply button to accept the changes made.
MLD Snooping Groups Settings
This window is used to display and configure the MLD snooping static group, and view MLD snooping group.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Groups
Settings, as shown below:
The fields that can be configured in MLD Snooping Static Groups Settings are described below:
Parameter
VID
Group Address
From Port - To Port
VID
Group Address
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to view all the entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Description
Enter the maximum response time, in seconds, advertised in MLD snooping
queries. The range is from 1 to 25.
Enter the robustness variable used in MLD snooping. The range is from 1 to 7.
Enter the interval at which the MLD snooping querier sends MLD group-specific or
group-source-specific (channel) query messages. The range is from 1 to 25.
Figure 5-53 MLD Snooping Groups Settings Window
Description
Enter the VLAN ID of the multicast group here. The range is from 1 to 4094.
Enter the IPv6 multicast group address here.
Select the appropriate port range used for the configuration here.
Click the radio button and enter a VLAN ID of the multicast group. The range is
from 1 to 4094.
Click the radio button and enter an IPv6 multicast group address.
108