D-Link DGS-1250 Series Reference Manual page 111

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
Parameter
Robustness Value
Last Member Query Interval
Click the Apply button to accept the changes made.
IGMP Snooping Groups Settings
This window is used to display and configure the IGMP snooping static group, and view IGMP snooping group.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Groups Settings, as shown below:
The fields that can be configured in IGMP Snooping Static Groups Settings are described below:
Parameter
VID
Group Address
From Port - To Port
VID
Group Address
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to view all the entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Description
Enter the robustness variable used in IGMP snooping. The range is from 1 to 7.
Enter the interval at which the IGMP snooping querier sends IGMP group-specific
or group-source-specific (channel) query messages. The range is from 1 to 25.
Figure 5-47 IGMP Snooping Groups Settings Window
Description
Enter a VLAN ID of the multicast group. The range is from 1 to 4094.
Enter an IP multicast group address.
Select the appropriate port range used for the configuration here.
Click the radio button and enter a VLAN ID of the multicast group. The range is
from 1 to 4094.
Click the radio button and enter an IP multicast group address.
102