Changing The Feed Rate Or Spindle Speed During Cutting - Roland CAMM-3 PNC-300 User Manual

Changing the Feed Rate or Spindle Speed During Cutting

The feed rate and spindle rotating speed set by the software can be changed while cutting is in progress.
This is done by first pausing the PNC-300 during cutting, then changing the feed rate or spindle speed. However, if the computer subsequently
sends a command to change the feed rate or spindle speed, the setting will change as specified by the new command. When set by software
or set directly on the PNC-300, the setting made last takes precedence.
Changing the Feed Rate
1
Press the [ENTER/PAUSE] key while cutting is in
progress. One cutting step is performed, after which
operation stops. The display changes to show the
following message.
3
Press the [ ] or [ ] key to move the blinking cursor
(" ") to "XY-SPEED."
To set the lowering speed of the head, move the
blinking cursor (" ") to "Z-SPEED."
5
Press the [ENTER] key.
26
Make sure
that "< >" appears.
2
Press the [MENU] key to make the following screen
appear on the display.
4
Press the [ ] or [ ] key to set the feed rate.
Setting range
X- and Y-axis : 0 to 60 mm/sec
Z-axis : 0 to 30 mm/sec