Roland CAMM-3 PNC-300 User Manual page 40

"REVOLUTION"
Default : ON
When set to "OFF," cutting can be performed without rotating the spindle.
"OVER_AREA"
Default : CONTINUE
This selects the action when the tool returns from a coordinate outside the cutting
range to a coordinate inside the range. (The tool cannot actually be moved outside
the cutting range, but the PNC-300's internal processing handles this as if it had.)
"CONTINUE" : Operation is not paused upon return to the cutting range. Cutting
continues without interruption.
"PAUSE" : Operation is paused when the tool returns to the cutting range.
"RESOLUTION"
Default : 0.01 mm/step
This selects the unit used for coordinates. Either 0.01 mm/step or 0.025 mm/step
can be selected.
"Z0_MEMORY"
Default : OFF
This toggles the Z0 point memory function on or off. When set to "ON," the Z0
point remains in memory even after the power is switched off.
"SENSE_HEIGHT"
Default : 8.00 mm/step
The thickness of the Z0 sensor can vary slightly due to conditions of temperature or
humidity. This allows the sensor thickness to be adjusted to match actual thickness.
"SMOOTH"
Default : TYPE2
Smoothing is a function for cutting smooth arcs and circles. This selects the type of
smoothing. Smoothing can also be switched off.
When shipped from the factory, the PNC-300 is set for "TYPE 2" smoothing. If
arcs cannot be cut well using this setting, try changing it to "TYPE 1" or to "OFF."
30