Roland CAMM-3 PNC-300 User Manual page 13

Liquid-crystal display
HOME key
SPINDLE TEST
ON/OFF key
* A confirmation beep is produced whenever a key is pressed.
Liquid-crystal display
Arrow keys
TOOL UP key
TOOL DOWN key
HOME key
Z0 key
Z1 key
Z2 key
MENU key
ENTER/PAUSE key
SPINDLE TEST
ON/OFF key
VIEW key
JOG handle
HANDLE FUNCTION
SELECT key
Making Settings with the Liquid-crystal Display
ENTER/PAUSE
Z1 key Z2 key
key
Z0 key
MENU key
The settings and selection choices (or values) for the PNC-300 are shown on this display. Error mes-
sages also appear here in the event of a problem.
Pressing an arrow key causes the XY table to move in the corresponding direction. Holding down the
key makes the XY table move faster (except during spindle rotation, when the speed of movement does
not change).
The arrow keys are also used together with the liquid-crystal display to manipulate settings, select items,
display other choices, and change values.
This key makes the cutting tool (blade) move in a positive direction on the Z axis (i.e., upward). Move-
ment is always at a constant speed.
This key makes the cutting tool move in a negative direction on the Z axis (i.e., downward). Movement
is always at a constant speed.
This key moves the cutting tool to the current home position (XY origin point).
This key moves the cutting tool to the current Z-axis origin point.
This key starts the spindle motor and moves the tool to the current tool-down position. Spindle rotation
and tool changing do not take place while the cover is open.
This key moves the tool to the current tool-up position.
This key scrolls through the menu on the liquid-crystal display (i.e., it changes the panel display).
This key is used to confirm settings, values, and selections made with the liquid-crystal display.
When pressed during cutting, operation is paused.
This key is used to start and stop the spindle motor. The spindle will not rotate while the cover is open.
This key raises the cutting tool to its highest point and moves the XY table to the front left.
This is used for inching the XY table and cutting tool (in steps of 0.01 mm (0.00039")), and also to set
the speed of the spindle motor.
This key is used together with the liquid-crystal display to select the function of the JOG handle.
Arrow keys TOOL UP key
TOOL DOWN key
VIEW key
HANDLE FUNCTION SELECT key
JOG Handle
3