Setting Z0 With The Z0 Position Sensor (Included With The Unit) - Roland CAMM-3 PNC-300 User Manual

Setting Z0 with the Z0 Position Sensor (Included with the Unit)

The Z0 sensor included with the unit is used to set the Z0 point on the
surface of the workpiece. The Z0 sensor is placed on the location which
is to serve as the Z0 point, and the Z0 point is set.
1
Install the Z0 position sensor.
Z0 position sensor
jack
3
Press the [ ] key to move the blinking cursor (" ") to
"SENSOR OFF," then press the [ENTER] key.
5
Place the Z0 position sensor on top of the workpiece.
Z0 position sensor
Z0 position sensor
Z0
2
Press the [MENU] key to make the following screen
appear on the display.
4
The display changes to indicate the message shown
below.
6
Press the arrow keys and the TOOL UP/DOWN keys
to move the cutting tool until its tip comes into
contact with the Z0 position sensor. Movement of the
cutting tool stops when it touches the Z0 position
sensor.
* "REPEAT" is displayed only
when the buffer size has been
expanded.
15