Roland CAMM-3 PNC-300 User Manual page 28

3
Press the [ ] or [ ] key to set the feed rate.
Spindle Motor Revolution Speed
1
Press the [MENU] key to make the following screen
appear on the display.
3
Rotate the JOG handle to set the speed of rotation.
RPM : Revolutions Per Minute
Cutting-in Amount
The cutting-in amount is set by setting Z1. (Refer to next page.)
18
Setting range
X- and Y-axis : 0 to 60 mm/sec
Z-axis : 0 to 30 mm/sec
Setting range:
3,000 to 8,000 rpm
4
Press the [ENTER] key.
2
Press the HANDLE FUNCTION SELECT key to
move the "*" on the screen to "??00 RPM."
Make sure
that "< >" appears.