Stopping The Cutting Process - Roland CAMM-3 PNC-300 User Manual

Stopping the Cutting Process

In the case that you begin cutting and then find that you have sent the wrong cutting data, perform the following operation.
1
Press the [ENTER/PAUSE] key while cutting is in
progress. One cutting step is performed, after which
operation stops. The display changes to show the
following message.
3
Press the [ ] key to move the blinking cursor (" ") to
"STOP," and then press the [ENTER] key.
28
2
Use the software to stop data output.
Device Name
PNC-300
Interface
RS-232C
Download data now. Click "CANCEL", then stop to download.
Download Data
Protocol
Baud rate : 9600
OK
Data bit : 8
Stop bit : 1
CANCEL
Parity : None
Handshake : Xon/Xoff