Roland CAMM-3 PNC-300 User Manual page 37

Changing the Spindle Speed
1
Press the [ENTER/PAUSE] key while cutting is in
progress. One cutting step is performed, after which
operation stops. The display changes to show the
following message.
3
Press the [ENTER] key.
5
Press the [ENTER] key.
Canceling the Paused State to Resume Cutting
After changing the feed rate or spindle speed, cancel the paused state. Cutting then resumes at the new feed rate or spindle speed.
1
Press the [MENU] key to make the following screen
appear on the display.
Make sure that
"< >" appears.
2
Press the [MENU] key to make the following screen
appear on the display.
4
Use the jog handle to set the spindle speed.
RPM : Revolutions Per Minute
2
Press the [ ] key to move the blinking cursor (" ") to
"CONTINUE," and then press the [ENTER] key.
Setting range:
3,000 to 8,000 rpm
27