Other Messages - Roland CAMM-3 PNC-300 User Manual

Other Messages

Besides error messages related to commands or communication parameters, the following messages may also appear on the display.
Message
This message appears if repeat cutting is attempted when the cutting data exceeds 1 MB. The
data cannot all fit in the PNC-300's data buffer, so repeat cutting cannot be performed. The
display can be cleared by pressing the [MENU] key.
This message appears if cutting is attempted while the cover is open. The display can be
cleared by pressing the [MENU] key.
This message appears if repeat cutting is attempted when the data buffer is empty. Send cutting
data before performing repeat cutting. The display can be cleared by pressing the [MENU] key.
The PNC-300 stops automatically if an excessive load is placed on the spindle during cutting. The
message shown at right appears at this time. The overload may be due to excessive hardness of the
material, an excessive amount of cutting, or a feed rate that is too fast. Investigate the problem and
eliminate the cause of the overload.
The error can be cancelled by switching the power to the unit off and then on again.
If the cover is opened during cutting, an emergency stop is performed and this message appears.
All cutting data stored in the PNC-300 is deleted, and cutting cannot be continued.
If this message appears, stop sending data from the computer. Switch the power off and back
on again to cancel the error.
This message appears if the connector terminal for the Z0 sensor starts to come loose from the
unit.
The message disappears and the error is canceled by completely detaching the Z0 sensor
terminal from the unit, or by inserting the terminal securely to obtain a stable connection.
Meaning
37