Table of Contents
Advertisement
U P G R A D E M A X P R O N V R S O F T W A R E
8
Overview
Upgrade to MAXPRO NVR 4.0
Upgrade is supported from MAXPRO NVR 3.1 SP1 or later version to MAXPRO NVR 4.0 Build
87 Rev H.
If you are upgrading from a version lower than 3.1 SP1 to MAXPRO NVR 4.0 then an error
message is displayed. Upgrade to v3.1 SP1 Build 70C on top of the lower versions and then
upgrade to NVR 4.0 Build 87 Rev H.
Note:
If you are upgrading to MAXPRO NVR 4.1 Build 123 Rev B then upgrade is supported as
explained below:
Taking the Database Backup
Honeywell recommends database backup before running the upgrade. Database backup can
be done from MAXPRO NVR Agent.
Figure 8-14
Note:
How to upgrade to MAXPRO NVR 4.0
1.
212
Ensure that Services.msc console is closed before Installing or
upgrading the MAXPRO NVR. See the
Defragmentation
section on page 65.
•
From NVR 4.0 87 Rev H to NVR 4.1 Build 123 Rev B
•
From NVR 4.0 87 Rev H SP1 to NVR 4.1Build 123 Rev B
•
From NVR 4.0 87 Rev H (beta) to NVR 4.1 Build 123 Rev B
Taking Database backup using the MAXPRO NVR Agent
In MAXPRO NVR 3.1 or later version, a new scheduled backup mechanism is
added which will retain the last 7 days of Database Backup. In case of upgrade, if
the backup is set in the system already then same backup drives are maintained
in the configuration and used in the new backup mechanism.
Or
If the backup is not set then by default the first recording drive is selected for
database backup according to the alphabetical order. If you want to change the
drive then edit the TakeNVRbackup.bat file which is available in
C:\Install\BackupData and mention the required drive name.
Insert the MAXPRO NVR 4.0 setup DVD in the DVD drive, browse the DVD drive, and then
double-click setup.exe
Or
Go to the MAXPRO NVR setup folder on your computer, and then double-click setup.exe. A
Before you Begin - Disable
MAXPRO NVR 5.0 Installation and Configuration Guide
- Quick Links:
- Installing the Software in the Server...
Hide quick links:
Advertisement
Table of Contents
