Figure 6-16 Camera Type Field Displaying "Onvif Device" For A Onvif Camera - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
Figure 6-16
You must add the discovered camera(s) using the Add Cameras button to view the model
name(s). After adding the camera(s), you can view the model name(s) from the Camera Type
drop-down list in the left pane of the Camera page.
AXIS and ONVIF cameras also support the TCP and UDP based streaming modes. You can
choose the required streaming mode during the configuration depending upon what camera
supports.
Tip: To discover and configure the AXIS Camera/Encoders as an ONVIF device in MAXPRO
NVRs, see Appendix B
Configuration (using ONVIF)
To add third party ONVIF cameras in MAXPRO NVR through Auto Discovery
1.
2.
3.
4.
5.
Tip: After adding a third party ONVIF camera model using Auto Discovery, you can also
manually add a new third party ONVIF camera. Click the Manual Add button located at the
bottom of the Camera page and then select the model from the Camera Type drop-down list.
Adding ONVIF devices manually when Auto discovery is not supported
MAXPRO NVR v3.5 or later supports manual addition of ONVIF cameras and encoders with
the support of additional device types - ONVIF DEVICE (for cameras) and ONVIF ENCODER
DEVICE (for encoders).
To manually add ONVIF devices in MAXPRO NVR when Auto Discovery is not supported
140
Camera Type field displaying "ONVIF DEVICE" for a ONVIF camera
MAXPRO®NVRs - AXIS Camera/Encoders Discovery and
section on page 343.
In the Camera page, click the Auto Discovery button. After the discovery select the
required check boxes of third party ONVIF cameras.
Under Settings, select the Video Format from the drop-down list.
Under Set camera credentials, type the User Name and Password of the third party
ONVIF camera.
Click Save.
Click the Add Cameras button to add the camera.
MAXPRO NVR 5.0 Installation and Configuration Guide