Figure 6-15 Adding Stream - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
Figure 6-15
Note:
4.
5.
Note:
138
Adding Stream
• Based on the type of camera the Add Stream button is enabled/disabled. If
the camera supports additional streams then the Add Stream button is
enabled. You can add streams until the button is enabled.
• System stream limit is 128. This is the maximum number of streams that can
be added including multi-stream for cameras and multi-channel encoders or
multi-imager 180/360 cameras. Multistream or Dual stream is not supported
for encorders.
Under Stream 2:
• Type the required Name for the additional stream.
• Select Enable Stream check box to enable the stream Or clear the check box to
disable this stream.
For the Stream 2 Recording, Schedules, Preference settings, repeat
step 14 of Configuring the Camera Properties
and configure multiple streams for a camera.
Ensure that the Resolution and FPS should match with the Camera and the NVR
secondary stream settings, else live video can not be displayed.
Ensure that you set the Primary stream for recording which is 720p resolution and
secondary stream for Live which is 4CIF. See
section for more information.
You can set the Bit rate value in the specific camera web page.
step 10
section on page 131. Similarly you can add
Recommended stream Settings
MAXPRO NVR 5.0 Installation and Configuration Guide
through