Figure 4-13 Reboot Prompt - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

Install ing Web Client
MAXPRO NVR 5.0 Installation and Configuration Guide
11. Click OK. The Finish dialog appears with the options to Validate and to Finish the
installation.
• Click Validate to verify the installed files on your NVR. If there are no errors then a
message appears - Setup has been validated successfully without any error.
Click here to view report. If there are errors, the message shows there are errors
and the report can be reviewed to identify the error and contact Honeywell technical
support if required to correct them on reinstall.
• Click Finish. The installation wizard starts all the services which may take a few
minutes. After the wizard closes, as mentioned in
Restart the system manually for the changes to take effect. If you are prompted to
reboot the system then the following message is displayed.
Figure 4-13 Reboot prompt
12. Click OK to complete the MAXPRO NVR installation.
Note:
In MAXPRO NVR 3.1 or later version, a new scheduled backup mechanism is
added which will retain the last 7 days of Database Backup. In a fresh installation
scenario, by default the first recording drive is selected for database backup
according to the alphabetical order. If you want to change the drive then edit the
TakeNVRbackup.bat file which is available in C:\Install\BackupData and
mention the required drive name.
• Issue: While installing NVR 5.0, a System Warning dialog with Unknown Hard Error
message is displayed
Cause: This issue may occur due to conflict between third party applications or due
to system file corruption.
Solution: Refer and perform the steps as explained in the Microsoft link
https://answers.microsoft.com/en-us/windows/forum/windows_8-
performance/explorerexe-system-warning-dialog-with-unknown/4c0be311-c9d5-
46e7-b352-c8656f5c0226?auth=1
Or
https://www.drivethelife.com/windows-10/fix-unknown-hard-error-windows-10.html
By default MAXPRO NVR 4.0 installs the Web Client component on your machine. It also
installs the MaxproWEBConfigurator utility to change or update the system and server
configuration. If you want to access the MAXPRO NVR Server using Web Client remotely
through a supported web browser then you should install Silverlight on the remote machine.
I N S T A L L I N G T H E N V R S O F T W A R E
Full Installation
step 10 it is recommended to
75