Henny Penny FlexFusion FPE-615 Service Instructions Manual page 115

Fault messages & troubleshooting
Remove the left side wall. Start cooking program. Is there an ignition process?
No Yes
Start cooking program. Measure the voltage on the Check the ionization electrode and replace if
wires to the ignition electrode. Is 24-28 V AC necessary. If the error persists, replace the ignition
present? electronics.
No
Yes
Is the current consumption of the glow electrode at least 1.4 A?
Yes
Replace glow electrode. If the error persists, replace
the ignition electronics.
No
Check that the gas fan functions properly. To do so, start a cooking program. Is the gas fan
functioning?
Yes No
Check that the gas solenoid valve functions Replace gas fan.
properly. Visual inspection and leak test of
heat exchanger
Check fuses and output voltage of the transformer for the glow electrode. Voltage present?
Yes No
Check connector on the ignition electronics.
Ensure power supply to the transformer.
Replace ignition electronics.
Replace transformer.
Service instructions 115