Troubleshooting - Targa CR 3 A1 Operating Instructions And Safety Instructions

CR 3 A1
5. Next, insert the screw cap (d) with the inserted metal contact (c) over the fuse (b) and then screw the
cap (d) clockwise onto the cigarette lighter plug housing (a).

14. Troubleshooting

You can solve most common problems yourself using the table below. If the problem persists
after checking the suggested solutions, please contact our Service Hotline (see page 50). Do not
attempt to repair the product yourself. Do not open the housing of the Dashboard Camera or of the car
charger as they contain no serviceable parts.
Error
Unable to power the
Dashboard Camera on.
The Dashboard Camera
suddenly powers off.
The Dashboard Camera fails to
respond and cannot be
switched off.
The recordings show stains or
shadows.
The "Need Class6 or Higher
SD Card" message is
displayed.
The "Custer size wrong. Please
format" message is displayed.
48 - English
Solution
The battery pack is empty. Recharge the battery.
The battery pack is empty. Recharge the battery.
Auto power-off is enabled. Check the settings (see "Auto Power Off"
in the "Setup menu" section on page 42).
Press the Reset switch (17). Use a pointed object to do this. Wait for a
few seconds. The Dashboard Camera should then work as normal
again. After performing a reset, all user-defined settings are lost,
except the date and time.
Clean the Dashboard Camera lens with a soft, dry, lint-free cloth. Do
not use any detergents or chemicals.
The inserted microSD memory card must support at least Speed Class
6. If necessary, insert a faster microSD memory card.
The inserted microSD memory card isn't properly formatted. Format it
again.