Connecting The Dashboard Camera To A Computer; Using A Card Reader - Targa CR 3 A1 Operating Instructions And Safety Instructions

CR 3 A1

12.2.1 Connecting the Dashboard Camera to a computer

1. Use the USB cable supplied to connect the Dashboard Camera to
an available USB port on a computer. Insert the Mini USB plug
(24) of the supplied USB cable into the Mini USB/charging
connector (14) of your Dashboard Camera and the USB Type A
plug (25) into a USB port on your computer.
2. The Dashboard Camera will then turn on automatically and you
will be asked to select the "Mass Storage" mode.
3. Press the OK button (5) to confirm.
The computer will now set up a removable disk that can be used to
access your recordings.
When connecting to the PC via the USB cable, the content of the SD memory card will be read-
only. This means you will not be able to delete, rename or write to any files on the Dashboard
Camera from the PC. It is only possible to play already-recorded content.

12.2.2 Using a card reader

If your computer has a card reader which is compatible with microSD or SD memory cards, you can read
the contents of the memory card directly. Remove the memory card from the powered-off Dashboard
Camera.
1. Insert the microSD card directly into the microSD card reader or into the SD card adapter.
2. If you are using the SD card adapter, insert it into the SD card reader on your computer (normally
labelled SD/MMC).
3. The PC will add the memory card contents under the drive letter representing the card reader in My
Computer.
4. Open My Computer on your PC and double-click on the drive representing the card reader.
5. All recorded files can be found in various folders on this disk drive.
6. Now you can copy the recorded files from the memory card into a folder of your choice on the
computer's hard disk.
46 - English