Charging With The Car Charger - Targa CR 3 A1 Operating Instructions And Safety Instructions

CR 3 A1
The charge LED (12) lights up red while charging. Once charging is complete, the charge LED (12) goes
out.

6.3.2 Charging with the car charger

WARNING!
connect the car charger after you have started your car engine.
You can connect the car charger to a 12V or 24V cigarette lighter.
1. Plug the Mini USB connector (28) of the car charger into the
Mini USB/charge port (14) on the Dashboard Camera.
2. Then connect the car charger with the contacts (27) to a
suitable cigarette lighter in your car.
The Dashboard Camera will then switch on and loop recording
will begin. Please note that recording can start only if a
properly formatted microSD memory card has been inserted
into the Dashboard Camera.
If the cigarette lighter in your vehicle can be turned on with the ignition key, this will ensure that recording
begins each time you start your vehicle's engine and thus all journeys will be recorded automatically. The
car charger LED (26) lights while the car charger receives power.
The charge LED (12) lights up red while charging. Once charging is complete, the charge LED (12) goes
out.
If the charge LED (12) does not light up, you may need to replace the car charger fuse. For more on this,
see "Replacing the car charger fuse" on page 47.
WARNING!
power all the time, the car battery discharges if you leave the Dashboard Camera turned on.
Therefore, to avoid discharging the battery to a level where the engine cannot be started
anymore, we recommend you to disconnect the car charger from the cigarette lighter of your car
when leaving the car.
18 - English
In order to protect your Dashboard Camera from any sudden voltage surges,
If your car's cigarette lighter does not switch off with the ignition key but supplies