Error Codes - Henny Penny OFE-391 Operator's Manual

4-2.

ERROR CODES

Display
"E-4" Control board overheating
"E-5" Shortening overheating
"E-6" Temperature probe failure
"E-41" Programming failure
"E-71" Pump motor relay failure or wiring
problem
"E32, FAN FAIL Air pressure switch open; clogged
ERROR, CHECK dilution box or faulty blower; open
BLOWER, drain switch; open high limit
CLEAN
DILUTIONBOX,
CALL HENNY
PENNY
SERVICE"
July 2003
In the event of a control system failure, the digital display shows
an error message. These messages are coded: "E-4","E-5", "E-
6", "E-32", "E-41" and "E-71". A constant tone is heard when an
error code is displayed, and to silence this tone, press any of the
product buttons.
Cause
Turn switch to OFF position, then turn switch back to ON;
if display still shows "E-4", the board is getting too hot;
check for signs of overheating behind the control panel;
once panel cools down the controls should return to nor-
mal; if "E-4" persists, have control panel replaced
Turn switch to OFF position, then back to ON; if display
shows "E-5", the heating circuits and temperature probe
should be checked; once the unit cools down, the controls
should return to normal; if "E-5" persists, have control
panel replaced
Turn switch to OFF position, then back to ON; if the
display shows "E-6", the temperature probe should be
checked; once the probe is repaired, or replaced, the
controls should return to normal; if "E-6" persists, have
control panel replaced
Turn switch to OFF position, then back to ON; if display
shows "E-41", the control should be re-initialized (See
Programming Section) if the error code persists, have
control panel replaced
Pump motor relay failure or
if contacts are stuck closed; check wiring on POWER/
PUMP switch, or at
wall receptacle; L1 and N may be reversed
Clean dilution box or replace blower if
have drain switch checked; reset
high limit or have high limit checked
60
Panel Board Correction
Replace relay
necessary;