Table of Contents
Advertisement
3-17.
SPECIAL
PROGRAM
MODE
Oct. 2005
The Special Program Mode is used to set more detailed
parameters listed below.
SP-1
·
Degrees Fahrenheit or Celsius
SP-2
·
Language: English, French, German, Spanish, and
Portuguese
SP-3
·
System initialization
SP-4
·
Audio volume
SP-5
·
Audio tone
SP-6
·
Type of shortening to be melted - liquid, solid
SP-7
·
Idle Mode
SP-8
·
Filter tracking
SP-9
·
Product buttons
SP-10 ·
Clean-out minutes
SP-11 ·
Clean-out temperature
SP-12 ·
Nominal amps reading
SP-13 ·
Amps reading low limit (percentage)
SP-14 ·
Amps reading high limit (percentage)
SP-15 ·
Program code change
SP-16 ·
Usage code change
SP-17 ·
Change shortening - A-Cook Cycles
SP-18 ·
Change shortening - B-Hours
If a bad code is entered, an alarm sounds and "BAD
CODE" shows on the display. Wait a few seconds, the
control reverts back to the Cook Mode, and repeat the
1.
Press and hold (PROG►) for 5 seconds until "L-2" and
"LEVEL 2", followed by, "SP PROG" and "ENTER CODE"
show in the display.
2.
Enter code 1, 2, 3, and "SP- 1 ", "TEMP, UNITS" show in
the display.
To exit from the Special Program Mode at any time, press
and hold (PROG►) button for 2 seconds, or to roll back to
previous
setting, press (◄INFO).
DEGREES FAHRENHEIT OR CELSIUS (SP-1)
a.
Follow steps 1 and 2 above.
b.
The display flashes "SP- 1" and "TEMP, UNITS",
along with "°F" or "°C". Press ▼▲ buttons to toggle
from "°F" to "°C", or vice versa.
45
above steps.
Advertisement
Table of Contents
