Henny Penny OFE-391 Operator's Manual page 38

3-10.
CHANGING THE
FILTER ENVELOPE
(CONT.)
July 2003
4.
Lift the filter screen assembly from the drain pan.
5. Wipe the shortening and crumbs from the filter drain pan.
Clean the filter drain pan with soap and water. Thoroughly
rinse with hot water.
6.
Unthread the standpipe from the filter screen assembly.
7.
Remove the crumb catcher and clean thoroughly with hot
water.
8. Remove the filter clips and discard the filter envelope.
9. Clean the top and bottom filter screen with soap and water.
Rinse thoroughly with hot water.
Be sure that the filter screens, crumb catcher, filter
clips, and the standpipe are thoroughly dry before
assembly of filter envelope as water will dissolve the
10. Assemble the top filter screen to the bottom filter screen.
11.
Slide the screens into a clean filter envelope.
12.
Fold the corners in and then double fold the open end.
13.
Clamp the envelope in place with the two filter retaining
clips.
14. Replace the crumb catcher screen on top of the filter paper.
Screw on the standpipe assembly.
15. Place complete filter screen assembly back into filter drain
pan and slide pan back into place beneath the fryer.
16.
Connect the filter union by hand. Do not use a wrench to
tighten.
17.
Slide the condensation drain pan back into place. The fryer
is now ready to operate.
31
filter paper.