Henny Penny OFE-391 Operator's Manual page 59

3-17.
SPECIAL
PROGRAM
MODE
(CONT.)
Oct. 2005
MANAGER CODE CHANGE (SP-15)
This allows the operator to change the program code, or manager
code (factory set at 1, 2, 3) used to access Product Programming,
Special Programming, Clock Set, Data Comm, and Heat Control
Modes.
a. Follow steps 1 and 2 above.
b. Press (PROG►) until "SP-15" and "CHANGE, MGR
CODE? 1=YES" show in display, along with "CODE".
c. Press 1 button. "ENTER NEW CODE, P=DONE, I=QUIT"
show in display. Press Product buttons with new code.
d. If satisfied with code, press (PROG►). "REPEAT NEW
CODE, P=DONE, I=QUIT", show in display. Press same
code buttons in step c.
e. If satisfied with code, press (PROG►). "*CODE
CHANGE*" shows in display.
f. If not satisfied with code, press (◄INFO) and
"*CANCELED*" shows in display, then reverts back to "SP-
15" and "CHANGE, MGR CODE? 1=YES". Then the above
steps can be repeated.
USAGE CODE CHANGE (SP-16)
This allows the operator to change the usage code (factory set at
1, 2, 3) used to reset the usage data in the Information Mode.
a. Follow steps 1 and 2 above.
b. Press (PROG►) until "SP-16" and "CHANGE, USG CODE?
1=YES" show in display, along with "USAGE".
c. Press 1 button. "ENTER NEW CODE, P=DONE, I=QUIT"
show in display. Press Product buttons with new code.
d. If satisfied with code, press (PROG►). "REPEAT NEW
CODE, P=DONE, I=QUIT", show in display. Press same
code buttons in step c.
e. If satisfied with code, press (PROG►). "*CODE
CHANGE*" shows in display.
f. If not satisfied with code, press (◄INFO) and
*CANCELED*" shows in display, then reverts back to "SP-
16" and "CHANGE, USG CODE? 1=YES". Then the above
steps can be repeated.
52