Table of Contents
Advertisement
3-16.
PROGRAMMING
(CONT.)
July 2003
3.
Press and release the desired product button (1 to 10).
Press ▼ to copy a product, erase a product,
preset a product, erase all products, or preset
all products. See Copy/Erase Preset Products
4.
Press and release (PROG►) . The name of that product
shows in the display. Ex., "NAME FRIES".
CHANGE PRODUCT NAMES
a.
Press and release ▼▲ and the first letter, or digit, starts
flashing.
b.
Press and release ▼▲ to change the flashing letter.
c.
To continue to the next letter, press (PROG►). Then press
▼▲ to change this letter.
d.
Repeat step c. until up to 7 letters are entered.
e.
Press and hold (PROG►) to exit Program Mode, or press
and release (PROG►) until "PRELOAD" shows in display
to continue with Program Mode.
5.
The Preload Mode allows the operator to drop large pieces
first, with the lid up, before loading the rest of the product.
The preload cycle always runs without pressure, which
always regulates to the Step 1 cook temperature. Press ▼▲
to set a preload time, or press (PROG►) if no preload
is desired.
6.
Press and release (PROG►) and "1. COOK TIME" shows in
the display along with the preset time. Press ▼▲ to change
the time. The time shows in minutes and seconds. Press
and hold the buttons, and the time will jump by 5-second
increments to a maximum of 59:59.
7.
Press and release (PROG►) and "1. TEMP" shows in the
display, along with the preset temperature on the right side of
the display. Press ▼▲ to change the temperature.
Press and hold the buttons and the temperature will jump by
5-degree increments to a max. of 380°F (193°C), and a min.
of 190°F (88°C).
40
section.
Advertisement
Table of Contents
