Henny Penny OFE-391 Operator's Manual page 48

3-16.
PROGRAMMING
(CONT.)
July 2003
8.
Press and release (PROG►) and "2. STEP 2 AT" shows in
display, along with a step 2 time. If no step 2 is desired, set
time to "0:00" and press (PROG►). If a step 2 is desired,
press ▼▲ and set a time. Then, press (PROG►) to set
temperature and pressure.
Up to 10 steps can be programmed for a product,
repeating the above step for each cooking step.
9. Press and release (PROG►) and "ALARM – 1 AT 0:00"
shows in the display. Press and release ▼▲ to set an alarm.
Ex., If a Cook Cycle was set at 3 minutes, and an alarm was
to go off after 30 seconds into the Cook Cycle, "2:30" would
be set in the display at this time. When the timer counts down
to 2:30 the alarm sounds.
After the alarm time is set, press (PROG►) and "ALARM"
and "TYPE" flashes in the display, with the alarm type on
the right side of the display. "TIME", "SHAKE", "STIR",
"ADD", and "LID" can be set by pressing ▼▲.
An alarm sounds and alarm type flashes, prompting the
operator to shake the basket, stir the product, or add product.
If "TIME" is selected, the time remaining flashes in the
display. If "LID" is selected, "CLOSE LID" flashes in the
display. The timer countdown is paused until the lid is closed
and timer button is pressed to restart the timer.
Up to four alarms can be programmed. After the first
one is set, the other alarms can be accessed by pressing
(PROG►) again.
10.
Press and release (PROG►) until "QUALITY TMR" shows
in the display along with the preset holding time. Press and
release ▼▲ to adjust the holding time, up to 59:59.
To exit the Program Mode at any time, press and hold
(PROG►) for 2 seconds.
41