Controls System Maintenance; Adjusting Accelerator Pedal - Toro 07362 Operator's Manual

Figure 64
1. Fan belt 2. Idler pulley
Controls System
Maintenance

Adjusting Accelerator Pedal

1. Position vehicle on level surface, stop engine and
engage the parking brake.
2. Adjust ball joint on accelerator cable (Figure 65) to
allow .100"–.250" of clearance between accelerator
pedal arm and top of diamond tread floor plate
(Figure 66), when a 25 lb. force is applied to center
of pedal. Tighten locknut.
Note: Engine must not be running and return
spring must be attached.
1. Accelerator cable
2. Ball joint
50
Figure 65
3. Locknut