Table of Contents
Advertisement
1. Fan belt
2. Idler pulley
Adjusting Accelerator Pedal
(Fig. 47)
If engine throttle lever does not contact high idle stop
when accelerator pedal is fully depressed, an
adjustment to the accelerator cable is required. Check
adjustment every 200 operating hours.
1.
Position vehicle on level surface, stop engine and
engage the parking brake.
Note: Engine must not be running and return
spring must be attached.
2.
Adjust ball joint on accelerator cable to allow
2.5–6.3mm (0.100"–0.250") clearance between
accelerator pedal and top of diamond tread floor
plate, when a 11kg (25 lb. force) is applied to
center of pedal. Tighten locknut.
2
3
1. Accelerator cable
2. Ball joint
3. Locknut
3.
Maximum high idle speed 3650 rpm. High idle
stop should not be adjusted.
1
2
Figure 46
1
Figure 47
Engine must be running so final adjustment can
be performed. To guard against possible
personal injury, engage parking brake and keep
hands, feet, face and other parts of the body
away from fan or other moving parts.
Cylinder Head Bolts
Re-torque initially after 50 operating hours and check
every 1000 operating hours or annually thereafter.
Engine Valve Clearance
Adjust initially at 50 operating hours and check every
600 operating hours or annually thereafter.
Changing Transaxle/Hydraulic
Fluid (Fig. 48)
Change Transaxle hydraulic fluid, filter and clean
strainer every 800 hours.
1.
Position the vehicle on a level surface, stop
engine, engage the parking brake and remove key
from ignition switch.
2.
Remove drain plug from side of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and
tighten plug when hydraulic fluid stops draining.
3.
Fill reservoir with approximately 7.1 l (7.5 qt.) of
Dexron III ATF. Refer to Check Hydraulic Fluid,
p 18.
4.
Start engine and operate to fill hydraulic system.
Recheck oil level and replenish, if required.
Important
Use only hydraulic fluids specified.
Other fluids could cause system damage.
43
WARNING
Advertisement
Table of Contents
