Light Switch; Oil Pressure Warning Light; Fuel Gauge - Toro Workman HD 07369 Operator's Manual

3rd High Lockout Switch
Move the 3rd high lockout switch (Figure 6) to the slow
position and remove the key to prevent the use of third
gear when in the High range. The engine will shut off
if the shift lever is moved to third gear when in High
range. The key is removable in either position.

Light Switch

Push the light switch (Figure 6), to toggle the headlights
on or off.

Oil Pressure Warning Light

The oil pressure warning light glows (Figure 6) if the
engine oil pressure drops below a safe level while the
engine is running. If the light flickers or remains on,
stop the vehicle, turn off the engine, and check the oil
level. If the oil level was low, but adding oil does not
cause the light to go out when the engine is restarted,
turn the engine off immediately and contact your local
Toro distributor for assistance.
Check the operation of warning lights as follows:
1. Apply the parking brake.
2. Turn the ignition key to the On position, but do not
start the engine. The oil pressure light should glow
red. If the light does not function, either a bulb is
burned out or there is a malfunction in the system
which must be repaired.
Note: If engine was just turned off, it may take 1 to 2
minutes for the light to come on.
Charge Indicator
Illuminates when the battery is being discharged. If the
light illuminates during operation, stop the vehicle, turn
off the engine and check for possible causes (Figure 6).
Check the operation of warning lights as follows:
• Apply the parking brake.
• Turn the ignition key to the On position, but do
not start the engine. The charge indicator and oil
pressure lights should glow. If any light does not
function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.

Fuel Gauge

The fuel gauge shows the amount of fuel in the tank. It
operates only when ignition switch is in the On position
(Figure 6). Red indicates low fuel level and blinking red
indicates near empty.
Power Point
Use the power point (Figure 6) to power optional 12
volt electrical accessories.
Choke
To start a cold engine, close the carburetor choke by
pulling the choke control (Figure 6) out to the On
position. After the engine starts, regulate the choke to
keep the engine running smoothly. As soon as possible,
open the choke by pushing in the choke control to
the Off position. A warm engine requires little or no
choking.
Passenger Hand Hold
The passenger hand hold is located on the dashboard
(Figure 7).
1. Passenger hand hold
Seat Adjusting Lever
The seats can be adjusted fore and aft for operator
comfort (Figure 8).
16
Figure 7
2. Storage compartment