Fuel Gauge - Toro Workman HD 07369 Operator's Manual

Charge Indicator
Illuminates when the battery is being discharged. If the light
illuminates during operation, stop the machine, turn off the
engine, and check for possible causes
Important: If the alternator belt is loose or broken, do
not operate the machine until adjustment or repair is
complete. Failure to observe this precaution may result
in damage to the engine.
Important: If the alternator belt is loose or broken, do
not operate the machine until adjustment or repair is
complete. Failure to observe this precaution may result
in damage to the engine.
Check the operation of the warning lights as follows:
•
Apply the parking brake.
•
Turn the ignition key to the O
do not start the engine. The coolant temperature, charge
indicator, and oil-pressure lights should glow. If any light
does not function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.

Fuel Gauge

The fuel gauge shows the amount of fuel in the tank. It
operates only when ignition switch is in the O
(Figure 7). Red indicates a low fuel level and blinking red
indicates near empty.
Power Point
Use the power point (Figure
electrical accessories.
Choke Control
To start a cold engine, close the carburetor choke by pulling
the choke control (Figure
engine starts, regulate the choke to keep the engine running
smoothly. As soon as possible, open the choke by pushing
in the choke control to the O
requires little or no choking.
(Figure 7).
/P position, but
N REHEAT
position
N
7) to power optional 12 V
7) out to the O position. After the
N
position. A warm engine
FF
Passenger Hand Hold
The passenger hand hold is located on the dashboard
8).
1. Passenger hand hold
Seat-Adjustment Lever
You can adjust the seats forward and rearward for your
desired comfort (Figure
1. Seat-adjustment lever
18
Figure 8
2. Storage compartment
9).
Figure 9
(Figure