Running Belt Troubleshooting - Precor Experience 700 line Series Service Manual

Running Belt Troubleshooting

The TRM700/800 series treadmill provide the following diagnostic tools to help isolate and
resolve running belt issues:
Belt Rating parameter that indicates the condition of the running belt.
l
Diagnostics Belt Speed Test can be used to monitor the drive motor load current
l
(Higher than typical motor current indicates a worn belt/deck condition)
On P62, P80, and P82 consoles, the Club Setting > Maintenance menu provides addi-
l
tional diagnostics to help determine the condition of the running belt and deck: Recom-
mended Action, Operating Condition. and Belt Rating status information.
Belt Rating Information
Belt Rating indicates the condition of the belt ranging from 10 (New) to 0 (Fully worn):
l
10 - New Belt
o
1 or 0:- Fully worn, replace the belt
o
Belt Rating parameter can be viewed in the following menus:
l
P10, P30, P30i and P31: Information Display (65): > Belt Rating
o
P62, P80, and P82: Club Settings (5651565) > Maintenance menu > Belt Rat-
o
ing
The amount of belt/deck friction increases as the belt rating number approaches 0. As
l
the friction increases so does the amount of motor current required to move the belt.Typ-
ically cleaning the belt and deck will reduce friction causing the drive motor to work less
resulting in a higher belt rating number.
Belt rating is an algorithm that incorporates the average drive motor load current (and
l
other parameters) of the last 100 5.5 mph to 12.5 mph workouts to derive the belt rating
wear number.
P10, P30, P30i and P31: The Belt Rating menu is also used to clear the history and
l
reset the belt rating number of averages to 10. The service tech should reset the belt rat-
ing after each belt/deck replacement (hold QUICKSTART down).
When the belt rating reaches 1 or 0, the
l
blue flashing state.
The ASL will automatically change back to blue solid when the belt rating has moved
l
above 1 (2 thru 10).
Procedure
1. Go to the console service menu and read the Belt Rating parameter:
P10, P30, P30i and P31 consoles: Information Displayy (65) > Belt Rating
1
Active Status Light: Service and maintenance status light.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
System Troubleshooting Procedures
1
ASL (Active Status Light)state will go to the
7 Troubleshooting
Page 210