Precor Experience 700 line Series Service Manual page 62

3. Verify that the Drive Belt tension is within New or Used Drive Belt tension Verification
Belt Tension specification:
a. If the belt tension is not within the belt Verification Belt Tension specification;
continue procedure to adjust tension to the tension Calibration Belt Tension spe-
cification.
b. If the belt tension is within the Verification Belt Tension specification; skip the
tension adjustment and skip to
Belt Condition
New
Used
Belt tension calibration adjustment
4. Walk the belt off the Drive Motor pulley. You can use your free hand to move the motor
flywheel to rotate the motor pulley and drive belt.
5. Loosen the four 1/2" hex Drive Motor mount fasteners and adjust the motor position as
needed (forward to increase tension or rearward to decrease tension) to meet the belt
tension Calibration Belt Tension specification. Only make small incremental changes
in motor position per adjustment to prevent over tensioning the belt.
Belt Condition
New
Used
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Drive Belt Tension and Alignment Adjustment
"Operation verification" on the next
Verification Belt Tension
100-120 lbs (45-54 kgs)
80-90 lbs (36-41 kgs)
Calibration Belt Tension
110 lbs +/- 10 (50 kgs +/- 4.5)
85 lbs +/- 5 (39 kgs +/- 2)
5 Adjustment Procedures
page.
Page 53