Drive Motor Cable Schematic; Procedure - Precor Experience 700 line Series Service Manual

Drive Motor Cable Schematic

Procedure

Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
3. Disconnect the Motor Controller "MTH" and "MOTOR" electrical connections:
a. Remove the
see "Motor Controller (MC) Replacement" on
b. Disconnect the MC "MTH" and "MOTOR" interface cable connectors, see
Controller (MC) Replacement" on
c. Remove the motor interface cable from the three frame cable clamps.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
2
Motor controller or motor controller module
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
1
unplug the power cord.
"Hood Cover Replacement" on
2
MC base from the mounting fasteners to allow connector access,
page 72.
page 101.
page 101.
6 Replacement Procedures
Drive Motor Replacement
"Motor
Page 125