Precor Experience 700 line Series Service Manual page 158

side. This procedure uses the front access method. If you do not have supports avail-
able, then use the alternative side access method, see
access" on page 65
Note: You can also access the jackscrew by laying the treadmill on its side, see
lift platform assembly access" on page 65
3. Access the service menu (51765761) and select INCLINE TEST. Use the incline con-
trol to set the incline level to 14.
4. Securely and safely place supports (e.g. car jack stands) under the left and right front
corners of the frame weldment.
5. Slowly lower the incline level in 0.5 increments until the complete weight of the frame is
setting on the supports. Verify the supports are stable and secure carrying the weight of
the treadmill. Continue lowering the incline level to "0". Incline level "0" is the lift motor
calibration reference incline level.
IMPORTANT: Its important to set the incline level to "0" (calibration ref level) before
switching the power OFF.
6. Switch the power OFF and
7. Disconnect the lift motor interface cable from the MC "LIFT" connector. Remove the
interface cable from the cable routing clamp.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
procedure.
1
unplug the power cord.
6 Replacement Procedures
"Side lift platform assembly
procedure.
Lift Motor Replacement
"Side
Page 149