Hood Cover Replacement - Precor Experience 700 line Series Service Manual

Click link to open procedure instructions.

Hood Cover Replacement

Hood Cover Replacement
ID
Removal Instructions
1. Remove the four #3 Phillips hood
fastener(s) for installation.
2. Grasp the lower edge of the hood
tab clip fasteners. Then carefully lift and slide the hood towards the back of the treadmill
through the targa uprights to remove.
Installation Instructions
1. Position the hood
through the targa uprights from the back towards the front. Grasp the bottom edge of
the hood cover and pull outwards while pressing down on the cover top at the front and
back to snap the tab clip fasteners into place.
2. Secure the hood
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Description
Hood Cover
cover screw fasteners. Retain part(s) and/or
cover and pull outwards while lifting to release the
cover over the front motor compartment by sliding the hood front
cover using the four #3 Phillips screw fasteners and fully tighten.
6 Replacement Procedures
Covers and Panels Replacement
Page 72