Precor Experience 700 line Series Service Manual page 135

4. Use a 5/16" socket (or nut driver) to remove the Drive Motor static bleed resistor ground
wire (Orange wire). Retain part(s) and/or fastener(s) for installation.
5. Use tape or marker to make a motor base position reference mark. This reference mark
will be used to help position the replacement motor installation position.
6. Remove Drive Belt tension by loosening the four Drive Motor
ers. Remove the Drive Belt by walking the belt off the Roller pulley and then the motor
pulley.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Drive Motor Replacement
1/2" hex head fasten-
Page 126