Displaying Dpv0 Alarms On Cfu Leds; Comparing Tags; Service Interface - Siemens Simatic CFU Commissioning Manual

Commissioning
8.7 Commissioning (offline)
8.7.3.4

Displaying DPV0 alarms on CFU LEDs

The CFU PA can signal DPV0 alarms via the fieldbus connection LEDs.
If the display is required, you must activate the parameter in HW Config.
You can find information on this in section "Assigning parameters to the PA master (parameter
overview - FB M) (Page 80)".
You can find information on the LED displays in section "Diagnostics via LED displays
(Page 91)".
8.7.3.5

Comparing TAGs

The CFU PA can automatically compare the name of the field device (TAG) with HW Config.
● If the display of inconsistencies is required, you must activate the parameter in HW Config.
You can find information on this in section "Assigning parameters to the PA master
(parameter overview - FB M) (Page 80)".
● You can find information on the LED displays in section "Diagnostics via LED displays
(Page 91)".
8.7.3.6

Service interface

You can configure one fieldbus connection of the CFU PA as a service port for the field devices
of this CFU (e.g. for calibrating the field devices in a specified environment).
● Settings on the engineering system or on the field device are not required.
● If the service port is enabled, you can calibrate field devices connected to the service port.
The field device behaves on the service port as it did on the original fieldbus connection.
82
Commissioning Manual, 07/2018, A5E39252870-AC
SIMATIC CFU