Ul / Csa Approval; Fm Approval - Siemens Simatic CFU Commissioning Manual

Technical specifications
12.1 General technical specifications
● ABNT NBR IEC 60079-15
● ABNT NBR IEC 60079-31
12.1.1.5

UL / CSA approval

Underwriters Laboratories Inc. in accordance with
R Ordinary locations
HAZ. LOC.
● UL 61010-2-201; First Edition, Dated January 24, 2014; IEC 61010-2-201:2017
(Note: This standard is supplemented by UL 61010-1, Third Edition, Dated May 11, 2012)
● CSA C22.2 No. 142 (Process Control Equipment)
Hazardous locations
● ISA 12.12.01
● CSA C22.2 No. 213
APPROVED for use in
Class I, Division 2, Group A, B, C, D Tx;
Class I, Zone 2, Group IIC Tx
Note the following information:
Note
This product must be installed according to the NEC (National Electric Code) stipulations.
When used in environments according to class I, division 2 (see above), the CFU must be
mounted in an enclosure that corresponds to at least IP54 according to EN 60529.
Installation instructions according to cULus
Installation instructions according to cULus
WARNING – Explosion Hazard - Do not connect or disconnect the device while circuit is live
unless area is known to be non-hazardous.
WARNING – Explosion Hazard - Substitution of components may impair suitability for Class
I, Division 2 or Class I, Zone 2.
This equipment is suitable for use in Class I, Division 2, Groups A, B, C or D; Class I, Zone 2,
Group IIC, or non-hazardous locations only.
12.1.1.6

FM Approval

Factory Mutual Research (FM) in accordance with
Approval Standard Class Number 3611, 3600, 3810
130
WARNING
Commissioning Manual, 07/2018, A5E39252870-AC
SIMATIC CFU