Siemens Simatic CFU Commissioning Manual page 74

Commissioning
8.7 Commissioning (offline)
Parameters for the CFU
The parameters for the CFU and the connections to the IO Controller are set at different objects
in in HW Config.
Object in HW Tab
1)
Config
PROFINET IO General
system
Update time
CFU General
Identification
Slot 0 General
(parameters for
the CFU)
Addresses
Slot 0/X1 (pa‐ General
rameter for inter‐
face to the PRO‐
Addresses
FINET IO sys‐
tem)
Synchronization
IO cycle
Media redundancy
74
Explanations
Name for the PROFINET IO system; settings for
automatic name assignment
Calculated or configured update time
Names and addresses of the CFU as node on
PROFINET IO
● PROFINET IO system information
● Setting the PROFINET IO system addresses
– Subnet information
– Subnet redundancy information
Higher level designation; location designation;
installation date; supplementary information
Information on CFU
(For information only / no change possible ex‐
cept comments.)
Diagnostic address for the CFU
Name for the interface of the BusAdapter to the
PROFINET IO system
Diagnostic address for the interface to the PRO‐
FINET IO system
Synchronization parameters for the interface to
the PROFINET IO system
Update time and response monitoring time for
the interface to the PROFINET IO system
(PROFINET installation > Isochronous mode >
PROFINET functions > Isochronous mode > En‐
gineering > Configuration)
Network configuration for the PROFINET IO sys‐
tem
(PROFINET functions > Media redundancy)
Supplementary information
1)
1)
As information only / no change
possible except comments.
PROFINET installation > Isochro‐
nous mode >
PROFINET functions > Isochro‐
nous mode > Engineering > Con‐
figuring
PROFINET functions > Media re‐
dundancy
Commissioning Manual, 07/2018, A5E39252870-AC
SIMATIC CFU