Siemens Simatic CFU Commissioning Manual page 90

Commissioning
8.9 Configuring with PDM Stand alone
Parameter assignment of CFU PA with SIMATIC PDM
1. Select the CFU PA in the tree structure.
2. Select the shortcut menu command Open Object.
SIMATIC PDM opens.
You can find information on the remaining procedure in section "Assigning parameters to
CFU online via SIMATIC PDM (Page 84)".
Detecting and configuring CFU PA field devices
Requirement:
● The CFU PA has been configured.
● Communication with the CFU PA has been established.
CFU behavior after switching on
Connected field devices are detected and you can configure the field devices.
You can find additional information on this in section "Using a wizard for CFU configuration
(Page 55)".
90
Commissioning Manual, 07/2018, A5E39252870-AC
SIMATIC CFU