Simplified Commissioning Of Connected Field Devices - Siemens Simatic CFU Commissioning Manual

Requirements
● The CFU device name is downloaded to the CFU PA online.
Automatic address assignment is successful only when the device name is set correctly.
Note
Local parameter assignment of CFU PA device name
Observe section "Assigning device names with existing configuration from HW Config
(Page 60)"
● An online connection between the ES and CFU PA can be established.
● The electrical wiring is complete (PS, DIQ, FB).
Procedure
1. Select the CFU PA in the component view.
2. Select the shortcut menu command Edit > Start SIMATIC PDM.
SIMATIC PDM opens.
3. In SIMATIC PDM, select the menu command Device > CFU PA ... Configuration>
The "CFU PA ... Configuration" dialog window opens.
4. Click the "Commissioning wizard" button.
The commissioning wizard is opened.
5. Follow the instructions in the commissioning wizard.
You can find information on this in section "Using a wizard for CFU configuration
(Page 55)".
8.8.2

Simplified commissioning of connected field devices

If you click the "Commissioning Wizard: Add/remove/replace field devices only" button, you
go directly to step 4/6 of the commissioning wizard.
Procedure
1. Open the "CFU ... Configuration" wizard.
You can find information on this in section "Using a wizard for CFU configuration
(Page 55)".
2. Click the "Commissioning Wizard: Add/remove/replace field devices only" button.
The commissioning wizard opens at step 4.
3. Perform the commissioning.
4. Configure the CFU PA in HW Config (without field devices).
5. Download the configuration to the CFU PA.
6. Run the "Read back IOs" function in HW Config. You can find information on this in section
"Read back IOs (Page 86)".
Result: The configuration is adopted from the wizard and is consistent.
SIMATIC CFU
Commissioning Manual, 07/2018, A5E39252870-AC
Commissioning
8.8 Commissioning (online)
85