Connectable Components; Mcp 483C Pn - Siemens SINUMERIK 828D Manual

Connectable components

7.1

MCP 483C PN

Description
The MCP 483C PN machine control panel enables user-friendly operation of the machine
functions. It can be used with a SINUMERIK 828D controller for machine-level operation of
milling and turning machines.
All keys are designed with replaceable caps for machine-specific adaptations. The key caps
can be freely inscribed using laser. Clear key caps can be used as an alternative.
The machine control panel is mounted from the rear with special tension jacks supplied with
the panel.
Operator controls
● Operating mode and function keys:
● Spindle control with override spindle (rotary switch with 16 positions)
● Feed control with override feed/rapid traverse (rotary switch with 23 positions)
● Key-operated switch (four positions and three different keys)
● Emergency-Stop button, two contact pairs (1 NO + 1 NC)
Interfaces
● PLC I/O Interface (transfer rate: 100 Mbit/s)
● Nine customer-specific inputs (e.g. for illuminated pushbuttons)
● Six customer-specific outputs
PPU
Manual, 03/2013, 6FC5397-2DP40-3BA1
– 50 keys with assigned LEDs
– Direction keys for milling machines with rapid traverse override
(The key covers for the direction keys for lathes are supplied.)
– Key type: Mechanical short-stroke keys
Note
Handwheel connections
A maximum of two handwheels can be connected to the SINUMERIK 828D. They must
be wired directly with terminal X143 of the PPU.
7
97