Siemens SINUMERIK 828D Manual page 112

Connectable components
7.1 MCP 483C PN
Name
Rapid traverse
dial
Rotary switch for
spindle
Rotary switch for
feed
Set of tensioners
Table 7- 13
Component
Keyset
Yellow backing plate
Table 7- 14
Component
Square key cap, can be
laser-labeled
Square key cap, for
inscription plates
Cable set
Removing the rotary switch
Note
For the machine control panel, use only electronic rotary switches.
Procedure:
1. Lever the cover
2. Remove the nut of collet
3. Remove the entire rotary knob
4. Remove the lock nut
112
Description
for 16-stage rotary switch
Spindle/rapid traverse override, electronic
rotary switch 1x16G, T=24, cap, knob,
pointer, spindle and rapid-traverse dials
Override feedrate / rapid traverse electronic
rotary switch 1x23G, T=32, cap, knob,
pointer, feedrate and rapid-traverse dials
Set of tensioners for supplementary
operator components with 2.5 mm profile,
20mm length
Accessories pack (for delivery ex works)
Description
Key caps for turning (labeled)
Ergo gray key caps (can be labeled)
Clear key caps (can be labeled)
for emergency stop
Accessories available for order
Description
1 set of 90, ergo-gray and 20 each
of red / green / yellow / medium
gray
1 set of 90, clear
For additional MCP control
devices, length 500 mm
③
off the rotary knob
①
with a wrench (width 10).
②
⑤
on the axis of the rotary switch
Quantity
②
(snap-on connection).
.
④
Quantity Order number
20 6FC5248–0AF30–0AA0
1 6FC5247–0AF12–1AA0
1 6FC5247–0AF13–1AA0
9 6FC5248–0AF14–0AA0
Quantity
Order number
1 6FC5248–0AF12–0AA0
1 6FC5248–0AF21–0AA0
60 6FC5247-0AA35-0AA0
with a wrench (width 14).
Manual, 03/2013, 6FC5397-2DP40-3BA1
9
30
30
1
PPU