Siemens SINUMERIK 828D Manual page 211

Connection example
When commissioning the system for the first time, the digital inputs/outputs are
correspondingly preassigned.
1)
2)
3)
Figure 7-49
See also
For the pin assignment of the DRIVE-CLiQ interfaces X100 - X103, please refer to Chapter
"DRIVE-CLiQ (Page 89)".
For further information on DC voltage and standards, please see Chapter "Power supply
connection (Page 72)".
PPU
Manual, 03/2013, 6FC5397-2DP40-3BA1
Rapid inputs must be shielded.
Jumper open, electrical isolation for digital inputs (DI)
can be parameterized as either input or output
Connection example NX10.3
Connectable components
7.7 NX10.3
211