Table of Contents
Advertisement
Chapter 4
Parameter Settings
With this scanner, communication, code types and other parameters can be set using one of two methods, the QR-coded
parameter menu or the configuration software (ScannerSetting_2D).* The set parameter values will be retained even after the
scanner is turned off.
Note: Scanner parameters and communications adapter parameters can both be stored in the memory of the scanner; it is also
possible to set the communications adapter from the scanner using Bluetooth
14
for details. There are codes for scanner setting
in the QR-coded parameter menu.
(1) Parameters can be set by pulling the trigger switch and reading the QR code for parameter setting (QR-coded parameter
menu).
(See
Chapter 13
for setting the scanner and
(2) Parameters can be set through the computer using the configuration software (ScannerSetting_2D)*. In this case, we
recommend that the scanner be set as the master device.
(It is possible to generate a batch setting QR Code with the configuration software, and set parameters by reading it with
the scanner.)
Note: Because Bluetooth® wireless communication is disconnected when the scanner is set using the configuration
software and batch setting QR code, reconnection is required once settings have been configured successfully.
However, when "Bluetooth® wireless communication connection" is set to "No change" using the configuration
software, Bluetooth® wireless communication will not be disconnected.
Note: Settings cannot be configured when the scanner is in the End operation state. Be sure to switch to the Start
operation state before setting. Refer to
Note: The configuration software cannot be used when HID (Human Interface Device Profile) is selected. Generate a
batch setting QR code with the configuration software and set parameters.
Note: Parameters will not be retained if the battery is low. Set the parameters after charging.
* The configuration software (ScannerSetting_2D) can be downloaded from our website "QBdirect" free of charge by
registered users.
http://www.qbdirect.net
(Section
13.2) and communications adapter setting
Chapter 14
for setting the communications adapter using the scanner.)
Section 2.1
for details regarding Start operation and End operation.
10
®
wireless communication. See
Chapter
(Section
14.2)
Hide quick links:
Advertisement
Table of Contents
