Denso GT20Q-SB User Manual page 69

Note 1: "GS1 DataBar" refers to all of the following codes:
GS1 DataBar Omnidirectional, GS1 DataBar Truncated, GS1 DataBar Limited, GS1 DataBar Stacked, GS1 DataBar Expanded,
GS1 DataBar Stacked Omnidirectional, GS1 DataBar Expanded Stacked
Note 2: These code marks are contained in the code data.
Note 3: Type 4 code mark is a code mark system that conforms to the AIM USA "Guidelines on Symbology Identifiers."
"m" suffix is a modifier character that differs depending upon options of individual symbologies as defined below.
Code Type
QR code
iQR code
MaxiCode
Data Matrix
Aztec
Interleaved 2 of 5
Code 39
Code 39 Full ASCII
Codabar
Code 128
Example: The code mark for Interleaved 2 of 5with option "Scanning enabled, with a check digit (Check digit
transmission disabled)" is "]I3".
]: Flag character (ASCII 93h)
I: Code character (Interleaved 2 of 5)
3: Modifier character (Refer to the above table)
Note 4: For code marks that do not conform to the AIM USA "Guidelines on Symbology Identifiers," the characters are the
same as those defined in Type 1.
"m"
(Modifier
character)
0 Model 1
1 Model 2
A No FNC1 in the 1st character position from start code
C FNC1 in the 1st character position from start code
E FNC1 in the 2nd character position from start code
0 Mode 4, mode 5
1 Mode 2, mode 3
1 ECC-200
2 ECC-200 (FNC1 in the 1st or 5th character position from start code)
3 ECC-200 (FNC1 in the 2nd or 6th character position from start code)
0 No options
1 FNC1 preceding the 1st message character
2 FNC1 subsequent to the 1st character or digit pair
0 Scanning enabled, without a check digit
1 Scanning enabled, with a check digit (Check digit transmission enabled)
3 Scanning enabled, with a check digit (Check digit transmission disabled)
0 Scanning enabled, without a check digit
1 Scanning enabled, with a check digit (Check digit transmission enabled)
3 Scanning enabled, with a check digit (Check digit transmission disabled)
0 Scanning enabled, without a check digit
1 Scanning enabled, with a check digit (Check digit transmission enabled)
3 Scanning enabled, with a check digit (Check digit transmission disabled)
0 No FNC1 in the 1st and 2nd character positions from start code
2 FNC1 in the 2nd character position from start code
56
Option
The