Denso GT20Q-SB User Manual page 91

(4) Image Output Setting Command
IMAGEOUT#1#m#n．．．．．．．．．．
Or
IMAGEOUT #1#m#n#o .........
The details of the four parameters are as follows:
1: Output format (file type)
B
J or J0
J1
J2
M: Image Size
0
2
4
N: Image Output Area
F
C
O: Whether to use a thumbnail
0
None or 1
2
(5) Operation
1. When the scanner receives the IMAGEOUT command, it captures the image and the beeper sounds three times. The
scanner then enters image transmission mode (Xmodem 1K Protocol).
2. "When thumbnail transmission is enabled"
Thumbnails (1/64 WVGA BMP files, 1/4 WVGA JPEG files) are repeatedly transmitted.
When the trigger switch is pulled, the scanner captures the image and begins image transmission (Xmodem 1K Protocol).
(The beeper sounds once when the trigger switch is pulled.)
"When thumbnail transmission is disabled"
The scanner immediately captures the image and begins transmission (Xmodem 1K Protocol) based on the set
parameters.
3. Once image transmission is completed, the beeper sounds once and the scanner returns from image transmission mode to
normal operation mode.
BMP format
JPEG format (standard)
JPEG format (high quality)
JPEG format (low quality)
Standard WVGA
1/4 WVGA
1/16 WVGA
Full screen
Screen center
Thumbnail transmission is disabled
1/64 WVGA BMP thumbnail
transmission
1/4 WVGA JPEG thumbnail
transmission
Thumbnail transmission is enabled
Thumbnail transmission is disabled
78